Biocomposites From Regenerated Cellulose Textile Fibers And Bio-Based Thermoset Matrix For Automotive ApplicationsShow others and affiliations
2013 (English)Conference paper, Published paper (Refereed)
Sustainable development
The content falls within the scope of Sustainable Development
Abstract [en]
Biocomposites were produced from regenerated cellulose fiber reinforcement and soybean based bio-matrix. Mechanical, thermal, viscoelastic and morphological results show the good potential of these composites to be used as structural materials in automotive industries. This article focuses on manufacturing and testing of these composites for engineering materials.
Regenerated cellulose fibers such as Lyocell and viscose were reinforced in soybean based thermoset matrix to produce composites by compression molding. Hybrid composites were produced by mixing both these fibers at known ratio and the total fiber content in composite was between 40 and 60 weight %. In general, Lyocell based composites showed better tensile properties than viscose based composites. Composites consisting 60 weight % Lyocell and rest with matrix had tensile strength of 135 MPa and tensile modulus of 17 GPa. These composites also showed good flexural properties; flexural strength of 127 Mpa and flexural modulus of 7 GPa. Dynamic mechanical thermal analysis showed that these composites had good viscoelastic properties. Viscose based composites had better percentage elongation during tensile test. These composites also showed relatively good impact and viscoelastic properties. Scanning electron microscope images showed that the composites had good fiber-matrix adhesion.
Several efforts are made to produce sustainable biomaterials to replace synthetic materials due to inherent properties like renewable, biodegradable and low density. Biocomposites play significant role in sustainable materials which has already found applications in automotive and construction industries. Many researchers produced biocomposites from natural fiber and bio-based/synthetic matrix and it had found several applications. There are several disadvantages of using natural fiber in composites; quality variation, place dependent, plant maturity, harvesting method, high water absorption etc. These composites also give odor which has to be avoided in indoor automotive applications. These natural fibers can be replaced with lignocelluloses, agro mass and biomass to develop biocomposites as they are from natural origin. Lyocell and viscose are manmade regenerated cellulose fibers which is from natural origin has excellent properties. These fibers can be used as reinforcements to produce biocomposites which can overcome most of the above listed disadvantages of natural fibers.
Many composites were made from natural fiber reinforcement and petroleum based synthetic matrix. Researchers have been finding ways to get matrix out of natural resources like soybean and linseed on chemical modifications. This article is focused on producing and testing sustainable material with regenerated cellulose and soybean based bio-matrix for automotive applications.
Place, publisher, year, edition, pages
2013.
Keywords [en]
Biocomposites, Fiber reinforced composites, Mechanical testing, thermal properties, Resource Recovery
National Category
Materials Engineering
Research subject
Resource Recovery
Identifiers
URN: urn:nbn:se:hb:diva-7063Local ID: 2320/12933OAI: oai:DiVA.org:hb-7063DiVA, id: diva2:887770
Conference
TexComp-11 Conference, Leuven, Belgium, September 16-20, 2013
2015-12-222015-12-22